ThingMagic Micro Carrier Board
ThingMagic Micro module (M6E-M) soldered to a carrier board with M6E form factor. The Micro is designed to meet the demands of high performance RFID handheld, mobile, and stationary readers. This embedded UHF RFID Reader offers two antenna ports and supports the ability to transmit up to +30 dBm for demanding applications. The edge connections for signals, power, and RF allow the module to be soldered directly to a motherboard as a standard component. The on-board connectors allow the module to be mated to a motherboard as an add-on option.
NOTE: This product is a carrier board– NOT a finished RFID reader – and is meant for OEM and developers to embed into products or to be used in the creation of a new finished reader. If you are interested in an existing finished reader product, check out our line of finished ThingMagic readers.
Data Sheet — ThingMagic Micro Carrier Board
Module Comparison — ThingMagic Micro Carrier Board
Reader Module Guide — ThingMagic Micro Carrier Board
- ThingMagic Micro Carrier Board Unit
Why buy this Carrier Board?
The ThingMagic Micro Carrier Board is a perfect solution for prototyping and proof-of-concept applications. The board includes the thermal advantages of solder-down and heat spreader. It can also be used in the M6e Family Development Kit.
- 2 MMCX RF antenna connectors.
- Integral heat spreader.
Optional Supported Protocols
The protocols below can be added to each reader at an additional cost. Please note additional equipment and services may be required to enable these protocols. If you have any questions, please contact us.
- IP-X 64, 128
- AEI ATA
The ThingMagic Micro Carrier Board is NOT intended to replace the compatible M6e Family Development Kit. This carrier board is recommended for use in conjunction with the ThingMagic Micro Embedded RFID Module Developer Kit.