null
Unboxing and Setting Up the ThingMagic Izar RFID Reader

Unboxing and Setting Up the ThingMagic Izar RFID Reader

Published by on

Introduction

This is part one of a four-part series that walks through unboxing and setting up the ThingMagic Izar RFID Reader and installing the ThingMagic URA. After that, the series navigates the user through the URA and then how to activate the RAINstream software to read and write tags.

[Audio Transcription Below]

Hey guys! today we are going to walk through all the steps that are involved in setting the ThingMagic Izar 4-Port UHF RFID Reader.

In this video, we are going to set up all the hardware pieces that you will need, then in the next video we are going to download ThingMagic's URA and set up our PC or laptop to connect to the reader.

To get started, you will need the following items:

First, you will want to connect the Izar Reader to your computer using the Ethernet cable. Connect one end of the Ethernet cable into the Lan-POE port on the reader, and the other end into your PC.

Next connect your reader to the Antenna by using the Antenna cable.

It is important that your antenna cable has the correct connectors for the reader and the antenna that you are using. In this case we are using an RP-TNC Male to RP-TNC Male Antenna cable.

Connect one end of the cable to the reader and the other end to the antenna.

As a best practice, you should only connect and disconnect antennas when a reader is powered off.

Finally, you'll want to connect the power supply to the Izar Reader.

Conclusion

That concludes our video on unboxing and setting up the ThingMagic Izar UHF RFID Reader - be sure to watch the next video in the series "Installing the ThingMagic URA and Connecting to Your Izar Reader".

For more information on the Izar Reader or RFID in general, check out our website, our YouTube channel, comment below or contact us!


To read more about ThingMagic Products, check out the links below!